ELECTRIC CAR PROJECT 9311 DIARY, JUN 94
---------------------------------------------------------------------
6/6/94
Fabricated new lower outside section of battery box out of 20 gauge
sheet steel and welded in place.

6/7/94
Installed 3/8-th inch bolt in battery box to serve as ground stud.
Wire wheeled and applied seam sealer to welded seams. Primed.

6/8/94
Applied "undercoat" to inside and outside of battery box. Also to
other "rehabilitated" areas inside trunk, near front.

6/9/94
Remove undercoating and seam sealer from battery box. Undercoat
did not set up properly over flexible seam sealer.

6/12/94
Removed right side heating system mixer box to see about making a
cover for the thus exposed heating duct entrance. Heating duct
sticks out from mounting surface precluding a simple flat cover so
reinstalled mixer box.

6/14/94
Continued to remove undercoat and sealer from battery box.

6/23/94
Applied "firm set" seam sealer to inside and outside seams of
battery box.

back diary next